VT - Test ANSWER KEY - MODULE 4
ANSWER KEY-MODULE 4
Posts
WELDING INSPECTION TECHNOLOGY WORKBOOK - MODULE 4
VT Test - MODULE 4 Q4-1 Which of the following is not considered a type of joint? a. butt b. T c. fillet d. corner e. edge Q4-2 The term for the type of joint formed when the two pieces to be joined lie in parallel planes and their edges overlap is: a. corner b. T c. edge d. lap e. butt Q4-3 The term for that portion of a single bevel butt joint where the two pieces to be joined come closest together is: a. radius b. joint root c. bevel angle d. groove angle e. none of the above Q4-4 In a single V-groove weld, the term for the sloped surfaces against which the weld metal is applied is: a. root face b. root c. groove faces d. groove angle e. bevel angle Q4-5 The term for the type of weld produced by filling an elongated hole in an overlapping member attaching it to the member beneath is: a. plug weld b. spot weld c. seam weld d. slot weld e. none of the above Q4-6 The term for the type of weld configuration formed...
WELDING INSPECTION TECHNOLOGY WORKBOOK - MODULE 3
VT Test - MODULE 3 Q3-1 Which of the following is a function of the flux coating of a SMAW electrode? a. insulating b. alloying c. deoxidation d. shielding e. all of the above Q3-2 In the AWS system of SMAW electrode designations, the next to the last digit refers to: a. impact strength b. electrode coating c. welding position d. strength e. none of the above Q3-3 Which of the following is an incorrect statement about a SMAW electrode designated as E7024? a. It is a low hydrogen type. b. The weld deposit has a minimum tensile strength of 70,000 psi. c. It is suitable for use in the flat and horizontal fillet positions only. d. It is an electrode for welding carbon steel. e. none of the above Q3-4 Of the following which is not an essential part of a typical SMAW system? a. constant current power supply b. wire feeder c. covered electrode d. electrode lead e. work lead Q3-5 Which of the following welding problems is the result ...
WELDING INSPECTION TECHNOLOGY WORKBOOK - MODULE 2
VT Test - MODULE 2 Q2-1 The welding inspector is exposed to which of the following safety hazards: a. radiation b. falling objects c. electrical shock d. eye hazards e. all of the above Q2-2 A document which covers safety in welding and cutting is: a. AWS D1.l b. API 1104 c. ANSI/ASC 249.1 d. ASME Section VI11 e. ASME B31.3 Q2-3 The most important component of an effective safety and health program is: a. safety rules b. safety procedures c. protective equipment d. welding helmet e. management support Q2-4 Safety training is mandated under provisions of a. AWS “Safe Practices” b. OSHA c. ASMECode d. Welding Handbook, Volume 2 e. none of the above Q2-5 The abbreviation ‘MSDS’ means: a. Management Support and Daily Safety b. Material Strength and Discontinuity Sheet c. Material Safety Data Sheet d. Material Strength and Data Sheet e. none of the above Q2-6 The abbreviation ‘TLV’ means: a. Total Linear volume b. Threshold ...
